EasyManuals Logo
Home>Cisco>Network Router>Catalyst 3550 Series

Cisco Catalyst 3550 Series User Manual

Cisco Catalyst 3550 Series
992 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #295 background imageLoading...
Page #295 background image
12-31
Catalyst 3550 Multilayer Switch Software Configuration Guide
78-11194-09
Chapter 12 Configuring VLANs
Configuring VMPS
Dynamic access ports cannot be monitor ports.
Secure ports cannot be dynamic access ports. You must disable port security on a port before it
becomes dynamic.
Dynamic access ports cannot be members of an EtherChannel group.
Port channels cannot be configured as dynamic access ports.
A dynamic access port can participate in fallback bridging.
The VTP management domain of the VMPS client and the VMPS server must be the same.
VQP does not support extended-range VLANs (VLAN IDs higher than 1006). Extended-range
VLANs cannot be configured by VMPS.
The VLAN configured on the VMPS server should not be a voice VLAN.
Configuring the VMPS Client
You configure dynamic VLANs by using the VMPS (server). The switch can be a VMPS client; it cannot
be a VMPS server.
Entering the IP Address of the VMPS
You must first enter the IP address of the server to configure the switch as a client.
Note If the VMPS is being defined for a cluster of switches, enter the address on the command switch.
Beginning in privileged EXEC mode, follow these steps to enter the IP address of the VMPS:
Note The switch port that is connected to the VMPS server cannot be a dynamic access port. It can be either
a static access port or a trunk port. See the “Configuring an Ethernet Interface as a Trunk Port” section
on page 12-19.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
vmps server ipaddress primary Enter the IP address of the switch acting as the primary VMPS server.
Step 3
vmps server ipaddress Enter the IP address of the switch acting as a secondary VMPS server.
You can enter up to three secondary server addresses.
Step 4
end Return to privileged EXEC mode.
Step 5
show vmps Verify your entries in the VMPS Domain Server field of the display.
Step 6
copy running-config startup-config (Optional) Save your entries in the configuration file.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3550 Series and is the answer not in the manual?

Cisco Catalyst 3550 Series Specifications

General IconGeneral
BrandCisco
ModelCatalyst 3550 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals