Cisco Catalyst 3550 Series User Manual

26-8
Catalyst 3550 Multilayer Switch Software Configuration Guide
78-11194-09
Chapter 26 Configuring System Message Logging
Configuring System Message Logging
Enabling and Disabling Sequence Numbers in Log Messages
Because there is a chance that more than one log message can have the same time stamp, you can display
messages with sequence numbers so that you can unambiguously refer to a single message. By default,
sequence numbers in log messages are not displayed.
Beginning in privileged EXEC mode, follow these steps to enable sequence numbers in log messages:
To disable sequence numbers, use the no service sequence-numbers global configuration command.
This example shows part of a logging display with sequence numbers enabled:
000019: %SYS-5-CONFIG_I: Configured from console by vty2 (10.34.195.36)
Defining the Message Severity Level
You can limit messages displayed to the selected device by specifying the severity level of the message,
which are described in Table 26-3.
Beginning in privileged EXEC mode, follow these steps to define the message severity level:
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
service sequence-numbers Enable sequence numbers.
Step 3
end Return to privileged EXEC mode.
Step 4
show running-config Verify your entries.
Step 5
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
logging console level Limit messages logged to the console.
By default, the console receives debugging messages and numerically
lower levels (see Table 26-3 on page 26-9).
Step 3
logging monitor level Limit messages logged to the terminal lines.
By default, the terminal receives debugging messages and numerically
lower levels (see Table 26-3 on page 26-9).
Step 4
logging trap level Limit messages logged to the syslog servers.
By default, syslog servers receive informational messages and
numerically lower levels (see Table 26-3 on page 26-9).
For complete syslog server configuration steps, see the “Configuring
UNIX Syslog Servers” section on page 26-10.
Step 5
end Return to privileged EXEC mode.

Cisco Catalyst 3550 Series Specifications

General

Brand	Cisco
Model	Catalyst 3550 Series
Category	Network Router
Language	English