To obtain a software license, you need the unique device identifier (UDI) of the device where the license is
to be installed.
The UDI has two main components:
• Product ID (PID)
• Serial number (SN)
The UDI can be viewed using the show license udi command in privileged Exec mode in Cisco Internet
Operating System (IOS) software.
For additional information on the UDI, see the << >>document on cisco.com.
Hardware Features of Cisco Catalyst 8300 Series Edge Platforms
This section describes the hardware features of Cisco Catalyst 8300 Series Edge Platforms
Built-In Interface Ports
The Cisco Catalyst 8300 Series Edge Platforms have multiple 10/100/1000 front panel ports and Small Form
Pluggables.
To comply with the Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety,
connect the Management Ethernet ports only to intra-building or unexposed wiring or cable. The
intra-building cable must be shielded and the shield must be grounded at both ends. The intra-building
port(s) of the equipment or subassembly must not be metallically connected to interfaces that connect
to the OSP or its wiring. These interfaces are designed for use as intra-building interfaces only (Type 2
or Type 4 ports as described in GR-1089-CORE) and require isolation from the exposed OSP cabling.
The addition of Primary Protectors in not sufficient protection in order to connect these interfaces
metallically to OSP wiring.
Warning
GE or SFP Ports
The following GE and SFP ports are available on the Catalyst 8300 series edge platforms:
GE Ports
The GE RJ-45 copper interface ports support 10BASE-T, 100BASE-TX, and 1000BASE-T.
SFP Ports
The small-form-factor pluggable (SFP) ports support 1Gbps SFP modules.
SFP+ Ports
The enhanced small-form-factor pluggable (SFP) ports support 10 Gbps SFP+ modules.
Hardware Installation Guide for Cisco Catalyst 8300 Series Edge Platforms
9
Overview
Hardware Features of Cisco Catalyst 8300 Series Edge Platforms
To Next Page
Loading...
Need help?
General
