C H A N G I N G B U L B S
The third stoplamp uses diodes
which cannot be replaced.
In case of malfunction, contact
In case of malfunction, contact
In case of malfunction, contact
Using a fl at screwdriver, detach
the transparent cover by lever-
ing it into the notch provided.
Lift up and pull the transparent
Using a small fl at screwdriver,
Fit the new bulb by fi rstly plac-
ing the angled base on the axis
of the clips, then press the bulb
Refi t the transparent cover by
inserting it from the edge oppo-
site the notch, then press on the
edge of the transparent cover.
check that the lamps work.