clearance to the “maximum
height” position and retain
this adjustment for as long
as the jack is under the vehi-
cle (do not use the hydraulic
Immobilise your vehicle on
horizontal, stable and non-
Ensure that any passengers
have left the vehicle and are
Never get underneath the vehi-
cle if it is supported only by
The jack and all of the tools
are specific to your vehicle.
Do not use them for any other
Have the original wheel repaired
and refi tted as soon as possi-
Park the vehicle on stable,
fi rm ground that is not slippery.
C H A N G I N G A W H E E L
If your vehicle is equipped with
“Hydractive III+” suspension,
with the engine running at idle,
adjust the ground clearance to
its maximum height. See chap-
ter “Hydractive III+ Suspen-
Switch off the ignition and
engage fi rst gear or reverse
gear depending on any slope
(for a vehicle with automatic
gearbox, select position P).
If your vehicle is fi tted with
“Hydractive III+” suspension,
position the chock, whichever
direction the gradient may be
in, in front of the front wheel
diametrically opposite to the
Position the jack at one of the
four jacking-points provided
on the subframe close to the
wheels, then use the handle to
unwind the jack until it reaches
Remove the protector from
Continue to extend the jack until
the wheel is a few centimetres
Undo the bolts, remove the
To Next Page
Loading...
Need help?
General
