A N T I - I N T R U S I O N A L A R M
First make sure all the doors are
The alarm is armed by pressing
With the alarm armed, the protec-
tions are active after 5 seconds
(perimeter) and 45 seconds (volu-
When the alarm is armed (on
standby), any intrusion will trigger
the siren for 30 seconds, accom-
panied by the direction indicators
The alarm then goes back on
standby. The triggering remains
memorised. The warning lamp on
alarm is deactivated by pressing
ing stops when you switch on the
Deactivating the volumetric
You can operate the alarm with
perimeter protection only, by deac-
tivating the volumetric protection (if
for example you wish to leave an
Within 10 seconds, press button
until the warning lamp remains on
Lock or deadlock the vehicle with
the remote control locking button.
It is recommended to deacti-
vate the volumetric detection when
washing the vehicle in order to pre-
vent the random triggering of the
The alarm is armed automatically,
2 minutes after the last door, or the
In order to prevent the alarm from
triggering when you open one of
the doors or the boot, it is essen-
tial to press the unlocking button
again on the remote control.
The siren is also triggered if there
is a cutting of the electrical sup-
ply. To stop it, restore the electrical
supply then press on the unlocking
If you want to lock your vehicle
without arming the alarm, just
If you lock your vehicle and a
door, or the boot, is still open,
the central locking does not
operate but the alarm will arm
itself after approx. 45 seconds.
The siren is automatically
deactivated (for example for dis-
connecting the battery) as soon as
the vehicle is unlocked using the