CITROEN C5 2008 User Manual

173
VI
A
1
P U N C T U R E K I T
Puncture kit
The puncture repair kit is located in
the boot, underneath the tool kit.
The puncture repair kit is a com-
plete system including a compres-
sor and a setting product.
Using the puncture repair kit
1
Remove the sticker found in the
kit, then stick it on the steering
wheel to remind you that you
are driving with a wheel that is
only fi t for temporary use and
that your speed is therefore lim-
ited.
2
Connect the fl ask
1
to the valve
of the tyre to be repaired.
3
Connect the electric cable to
one of the vehicle's 12V sock-
ets.
4
With the engine running, start
the compressor by pressing on
button
A
until the tyre pressure
reaches 2,0 bars. If you cannot
reach a pressure of 2 bars, the
tyre is not repairable.
5
Remove and store the com-
pressor.
6
Drive off immediately, for a few
miles at reduced speed, to allow
the puncture repair to set.
7
Adjust the tyre pressure using
the compressor according to
the recommendations for the
vehicle, and check that there
is no air escaping (no loss of
pressure). If you cannot reach
a pressure of 2 bars, the tyre is
not repairable.
8
Do not exceed 110 km/h (68 mph).
The tyre must be examined,
then repaired or replaced as
soon as possible by a profes-
sional.
Warning, the fl ask of puncture repair gel contains ethylene-glycol, a product that is toxic if ingested
and irritating for the eyes.
Keep out of the reach of children.
After use, do not dispose of the fl ask in the natural environment, but return it to a CITROËN dealer
or to a recognised recovery facility.
This repair kit is available from a CITROËN dealer.

CITROEN C5 2008 Specifications

General

Brand	CITROEN
Model	C5 2008
Category	Automobile
Language	English