ID-FLX Lite & Telecom Global Guide
17
4.4 Extension plug-in modules
4.4.1 Extension plug-in modules installation
To insert the module, you must open the cover first (use screwdriver to open) and then insert the module into
slot. Once you have inserted it, the module will snap under plastic teeth. It is supposed to be installed
permanently. Should you need to remove it, the safest way is to remove whole back cover and than remove
module manually.
For configuration of extension plug-in modules go to LiteEditand press button in Modify configuration
window.
4.4.2 IL-NT AOUT8
IL-NT AOUT8 is optional plug-in card. Through this card can the controller drive up to 8 VDO style
industrial/automotive gauges. This is to provide visual indication of typically ECU values without installing
additional sensors on the engine. PWM signal emulates sensor which would be typically mounted on the
engine. Sensor/gauge curve and value are configured in LiteEdit PC tool. Any analog value from the controller
may be configured to the outputs. All outputs operate as PWM signal at 1200Hz.
To Next Page
Loading...
Need help?
General
