ID-FLX Lite & Telecom Global Guide
67
Input Analog input
Binary output Load Switch
Setpoints Load limit
Load CMP Input = Actual Load
Load CMP On = 2000
Load CMP Off = 2200
5.15.11 AUT mode: Engine regulation by RPM control – overview
Functions below can automatically change the engine RPM to keep value measured on controller (plug-in
module) Analog input (e.g. Pressure) on adjusted level.
Functions 3 = PI loop and 4 = Comparator with Hysteresis (CMPH) are available. The function setup is done by
corresponding setpoints in Regulator group. This group has one PI loop and one CMPH.
The PI function output is Speed request transmitted via J1939 or Analog output. Both functions can use
controller or plug-in IL-NT-AIO module Analog inputs.
Note: In Regulator is input only from analog inputs or from RPM-BI3.
Condition Speed request
Binary output
SpeedSwitch
OFF mode Idle speed (page 115) = 0
MAN mode Manual In operation
AUT mode Automatic by PI loop In operation
Stop = Not Running Idle speed (page 115) In operation
Sd protection Idle speed (page 115) In operation
LBI R Reg Disable = 1 Reg Bias (page 127) In operation
To Next Page
Loading...
Need help?
General
