Dahua NVR100 series User Manual

144
○
1 . Loosen the screws of the upper
cover and side panel.
○
2 Connect the one end of the
HDD data cable and the power
cable to the mainboard.
○
3 Connect the other end of the
HDD data cable and the power
cable to the HDD.
○
4 Place the HDD in accordance
with the four holes on the bottom of
the chassis.
○
5 Turn the device upside down;
fix the screws to secure the HDD
on the bottom of the chassis.
○
6 Put the cover in accordance
with the clip and then fix the
screws on the rear panel and side
panel.
3.4.4 NVR42/42N/42-P/42-8P/42-16P/72/72-8P/42-4K/42-8P-4K/52-4KS2/52-8P-4KS2/52
-16P-4KS2/22-S2/22-P-S2/22-8P-S2/42-4KS2/42-P-4KS2/42-8P-4KS2/42-16P-4KS
2/5224-24P-4KS2 Series
The following figures are based on the NVR 72-8P series.
○
1
Loosen the screws of the rear
panel and side panel.
②Place the HDD in accordance with
the four holes in the bottom.
③Turn the device upside down and
then secure the screws firmly. It is to
fix the HDD on the chassis.

Dahua NVR100 series Specifications

General

Brand	Dahua
Model	NVR100 series
Category	Network Hardware
Language	English