Application Guide | iC2-Micro Frequency Converters
1 Introduction and Safety
1.1 Purpose of this Application Guide
This application guide is intended for qualified personnel such as:
l Automation engineers
l Application and product specialists who have experience operating with parameters and basic knowledge of AC drives.
The application guide, which provides information on the parameters to configure and control the frequency converter, procedures
to operate the user interfaces of the iC2-Micro Frequency Converters, typical application examples with recommended settings, and
troubleshooting of alarms and warnings that might occur.
1.2 Additional Resources
Following are the additional resources available to further understand the features, safely install, and operate the iC2-Micro Frequency
Converters.
l The operating guide, which provides information about the installation, commissioning, and maintenance of iC2-Micro Frequency
Converters.
l The design guide, which provides technical information to understand the capabilities of the iC2-Micro Frequency Converters for
integration into motor control and monitoring systems.
1.3 Version History
This manual is regularly reviewed and updated. All suggestions for improvement are welcome.
The original language of this manual is in English.
Manual Version Remarks
AB413939445838en, version 03 Information in this version of the manual applies to software version 1.20.
1.4 Safety Symbols
The following symbols are used in Danfoss documentation.
DANGER
Indicates a hazardous situation which, if not avoided, will result in death or serious injury.
WARNING
Indicates a hazardous situation which, if not avoided, could result in death or serious injury.
CAUTION
Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
NOTICE
Indicates information considered important, but not hazard-related (for example, messages relating to property damage).
The guide also includes ISO warning symbols related to hot surfaces and burn hazard, high voltage and electrical shock, and referring to
the instructions.
Danfoss A/S © 2024.03 AB413939445838en-000301 / 130R1254 | 11
To Next Page
Loading...
Need help?
General
