Selection number Selection name Selection description
2 Logic AND The fieldbus/serial communication port and a digital input
trigger the preset reference selection.
3 Logic OR The fieldbus/serial communication port or a digital input triggers
the preset reference selection.
7.6.4.3 Reference (Menu Index 5.5.3)
P 5.5.3.1 Reference Range
Use this parameter to select the range of the reference signal and the feedback signal.
Default value: 0 [Min–Max] Parameter type: Selection
Parameter
number:
300 Unit: –
Data type: enum Access type: Read/Write
The following are the selections for the parameter.
Selection number Selection name Selection description
0 Min–Max Select the range of the reference signal and the feedback signal.
Signal values can be positive only, or positive and negative.
1 -Max–Max For both positive and negative values (both directions), relative
to P 5.8.1 Rotation Direction.
P 5.5.3.2 Reference/Feedback Unit
Use this parameter to select the unit to be used in Process PID Control references and feedback.
Default value: 3 [Hz] Parameter type: Selection
Parameter
number:
301 Unit: –
Data type: enum Access type: Read/Write
The following are the selections for the parameter.
Selection number Selection name
0 None
1 %
2 RPM
3 Hz
4 Nm
5 PPM
156 | Danfoss A/S © 2024.03 AB413939445838en-000301 / 130R1254
Application Guide | iC2-Micro Frequency Converters
To Next Page
Loading...
Need help?
General
