Table 20: Default Settings (continued)
Category Parameter index Parameter name Default setting Parameter number
5.9.2 Jog Reference 5.0 Hz 311Jog
5.9.1 Jog Ramp Time 3s 380
5.5.3.3 Reference Maximum Value is automatically
calculated according
to motor data.
303Reference limits
5.5.3.4 Reference Minimum 0 302
5.6 Reference Handling
5.6.1 Local/Remote Reference
Local reference
The local reference is active when the drive is operated and adjusted by Up and Down buttons of the control panel.
Remote reference
The reference handling system for calculating the remote reference is shown in the Figure 43.
66 | Danfoss A/S © 2024.03 AB413939445838en-000301 / 130R1254
Application Guide | iC2-Micro Frequency Converters
To Next Page
Need help?
General
