Use this parameter to select the function of the Stop/Reset button. To avoid accidental stop or reset of the drive from control panel, select
[0] Disabled. The setting can be locked by P 6.6.20 Password.
Default value: 1 [Enabled] Parameter type: Selection
Parameter
number:
44 Unit: –
Data type: enum Access type: Read/Write
The following are the selections for the parameter.
Selection number Selection name
0 Disabled
1 Enabled
7 Reset Only Enabled
7.6.4.2 Digital/Bus (Menu Index 5.5.2)
P 5.5.2.1 Coasting Select
Use this parameter to select whether the coasting function is controlled via the terminals (digital input) and/or via the bus.
NOTICE
This parameter is active only when P 5.5.1.1 Control Place Selection is set to [0] Digital and control word.
Default value: 3 [Logic OR] Parameter type: Selection
Parameter
number:
850 Unit: –
Data type: enum Access type: Read/Write
The following are the selections for the parameter.
Selection number Selection name Selection description
0 Digital input Activate the coasting command via a digital input
1 Bus Activate the coasting command via the serial communication
port or fieldbus option.
2 Logic AND Activate the coasting command via the fieldbus/serial
communication port and 1 extra digital input.
3 Logic OR Activate the coasting command via the fieldbus/serial
communication port or via 1 of the digital inputs.
P 5.5.2.2 Quick Stop Select
Use this parameter to select whether the Quick Stop function is controlled via the terminals (digital input) and/or via the bus.
152 | Danfoss A/S © 2024.03 AB413939445838en-000301 / 130R1254
Application Guide | iC2-Micro Frequency Converters
To Next Page
Loading...
Need help?
General
