Application Guide | iC2-Micro Frequency Converters
NOTICE
This parameter is active only when P 5.5.1.1 Control Place Selection is set to [0] Digital and control word.
Default value: 3 [Logic OR] Parameter type: Selection
Parameter
number:
851 Unit: –
Data type: enum Access type: Read/Write
The following are the selections for the parameter.
Selection number Selection name Selection description
0 Digital input Activate the quick stop command via a digital input.
1 Bus Activate the quick stop command via the serial communication
port or fieldbus option.
2 Logic AND Activate the quick stop command via the fieldbus/serial
communication port and also via 1 of the digital inputs.
3 Logic OR Activate the quick stop command via the fieldbus/serial
communication port or via 1 of the digital inputs.
P 5.5.2.3 DC Brake Select
Use this parameter to select whether the DC brake is controlled via the terminals (digital input) and/or via the fieldbus.
NOTICE
This parameter is active only when P 5.5.1.1 Control Place Selection is set to [0] Digital and control word.
Default value: 3 [Logic OR] Parameter type: Selection
Parameter
number:
852 Unit: –
Data type: enum Access type: Read/Write
The following are the selections for the parameter.
Selection number Selection name Selection description
0 Digital input Activate the DC brake command via a digital input.
1 Bus Activate the DC brake command via the serial communication
port or fieldbus option.
2 Logic AND Activate the DC brake command via the fieldbus/serial
communication port and additionally via 1 of the digital inputs.
3 Logic OR Activate the DC brake command via the fieldbus/serial
communication port or via 1 of the digital inputs.
P 5.5.2.4 Start Select
Danfoss A/S © 2024.03 AB413939445838en-000301 / 130R1254 | 153
To Next Page
Loading...
Need help?
General
