Parameter
number:
507 Unit: %
Data type: uint16 Access type: Read/Write
P 9.4.4.8 T18 Low Duty
When setting variable duty cycle pulse signal as the reference, use this parameter to enter the pulse PWM input low duty (%) that
corresponds to the low reference value in P 9.4.4.4 Term. 18 Low Ref./Feedb. Value.
Default value: 0 Parameter type: Range (0–9900)
Parameter
number:
506 Unit: %
Data type: uint16 Access type: Read/Write
7.9.2.5 T15 as Pulse Output (Menu Index 9.4.5)
P 9.4.5.1 T15 Pulse Output Variable
Select the desired output on terminal 15.
Default value: 0 Parameter type: Selection
Parameter
number:
560 Unit: –
Data type: enum Access type: Read/Write
The following are the selections for the parameter.
Selection number Selection name
0 No Operation
45 Bus Control
48 Bus Control, Timeout
100 Output Frequency
101 Reference
102 Process Feedback
103 Motor Current
104 Torque Relate to Limit
105 Torque Relate to Rated
106 Power
107 Speed
109 Max Out Frequency
113 PID Clamped Output
246 | Danfoss A/S © 2024.03 AB413939445838en-000301 / 130R1254
Application Guide | iC2-Micro Frequency Converters
To Next Page
Loading...
Need help?
General
