Danfoss PVED-CLS User Manual

148 | © Danfoss | August 2018 AQ00000211
ENGINEERING TOMORROW
17.3 FMI LIST
In PVED-CLS the standard FMI from J1939-73 Appendix A page 130 are used as much as possible. However, in some
cases some of the reserved area FMI’s are redefined to suit the need.
The List of FMI’s used in PVED-CLS is found below:
Index Failure mode
0
0 - Data valid, but above normal operational range - Most severe level
1
1 - Data valid, but below normal operational range - Most severe level
2
2 - Data erratic, intermittent or incorrect
3
3 - Voltage above normal or short-circuit to high source
4
4 - Voltage below normal or short-circuit to low source
5
5 - Current below normal or open circuit
6
6 - Current above normal or grounded circuit
7
7 - Mechanical system not responding or out of adjustment
8
8 - Abnormal frequency or pulse width or period
9
9 - Abnormal update rate
10
10 - Abnormal rate of change
11
11 - Unknown root-cause
12
12 - Bad intelligent device or component
13
13 - Out of calibration
14
14 - Special instructions
15
15 - Data valid, but above normal operating range - Least severe level
16
16 - Data valid, but above normal operating range - Moderately severe level
17
17 - Data valid, but below normal operating range - Least severe level
18
18 - Data valid, but below normal operating range - Moderately severe level
19
19 - Received network data in error
20
20 - Data drifted high
21
21 - Data drifted low
22
22 - Message missing
23
23 - Unintended Steering
24
24 – Reserved
25
25 - Signal crosscheck failed
26
26 - No steering
27
27 - Unable to return to neutral
28
28 - Not in neutral at Power-up
29
29 - Stuck Open
30
30 - Stuck Closed
31
31 - Condition exists
Table 63
17.4 PARAMETER LIST

Danfoss PVED-CLS Specifications

General

Brand	Danfoss
Model	PVED-CLS
Category	Controller
Language	English