Danfoss VLT AutomationDrive FC 302 Design Guide

FC 300 Design Guide
How to Program
" Parameter Selection
In the Main menu mode, the parameters are
divided into groups. Select a parameter group
by means of the navigation keys.
The following parameter groups are accessible:
Group no. Parameter group:
0 Operation/Display
1Load/Motor
2Brakes
3 References/Ramps
4 Limits/Warnings
5 Digital In/Out
6 Analog In/Out
7 Controllers
8 Comm. and options
9Profibus
10 CAN f ieldbus
11 Reserved com. 1
12 Reserved com. 2
13 Prog. Features
14 Special functions
15 Drive information
16 Data readouts
After selecting a parameter group, choose a
parameter by means of the navigation keys.
The middle section on the display shows the
parameter number and name as well as the
selected parameter value.
130BP067.10
" Changing Data
The procedure for changing d ata in a parameter is the same both in the Quick menu or the
Main me nu mode. Press [OK] to change the selected parameter
.
The procedure for changing data depends on whether the selected parameter represents
a numerical data value or a text value.
" Changing a Text Value
If the selec ted parameter is a text value,
change the
text value by means of the up/down navigation keys.
The up key increases the value, and the down
key decreases the value. P lace the curso
ronthe
value you want to save an d press [OK].
130BP068.10
128
MG.33.B3.22 - VLT is a registered Danfoss trademark

Danfoss VLT AutomationDrive FC 302 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 302
Category	DC Drives
Language	English