FC 300 Design Guide
How to Install
" IP 21/Type 1 (N E M A 1) Enclosure Kit
A-Topcover
B-Brim
C-Basepart
D-Basecover
E-Screw(s)
Place the top cover as shown. If an A or B option
is used the brim must be fitted to c over the top
inlet. Place the base part C at the bottom of the
drive and use the clamps from the accessory bag
to correctly fasten the cables. Holes for cable
glands:
Size A2: 2x PG16 (½") 3xPG21 (3/4")
Size A3: 3xPG16 ( ½") 3xPG21 (3/4")
84
MG.33.B3.22 - VLT is a registered Danfoss trademark
To Next Page
Loading...
Need help?
General