Danfoss VLT AutomationDrive FC 302 Design Guide

FC 300 Design Guide
How to Program
" Parameters: Refer-
ence/Ramps
" 3-0* Reference Limits
3-00 Reference Range
Option:
*
Min. - Max [0]
-Max - +Max [1]
Function:
Settings for the reference signal and the feedback
signal. They can both be positive or positive
and negative. The minimum limit ma y have a
negative value, unless Speed control, closed
loop is selected (par. 1-00).
3-01 Refere nce/Feedback Unit
Option:
None [0]
*
%[1]
RPM [2]
Hz [3]
Nm [4]
bar [5]
Pa [6]
PPM [7]
CYCLE/min [8]
PULSE/s [9]
UNITS/s [10]
UNITS/min [11]
UNITS/h [12]
°C [13]
F[14]
m
3
/s [15]
m
3
/min [16]
m
3
/h [17]
t/min [23]
t/h [24]
m[25]
m/s [26]
m/min [27]
in wg [29]
gal/s [30]
gal/min [31]
gal/h [32]
lb/s [36]
lb/min [37]
lb/h [38]
lb ft [39]
ft/s [40]
ft/min [41]
l/s [45]
l/min [46]
l/h [47]
kg/s [50]
kg/min [51]
kg/h [52]
ft
3
/s [55]
ft
3
/min [56]
ft
3
/h [57]
Function:
Select one of the units in par. 3-01 used
in the P rocess PID Control.
3-02 Minimum Reference
Range:
-100000.000 - par. 3-03
*
0.000 Unit
Function:
The Minimum Reference gives the minimum
value obtained by the sum of all refere
nces.
Minimum Reference is only active when par.
3-00 is set to Min. - Max [0].
Speed control, closed loop: R PM
Torque control, speed feedback: Nm.
Process control unit in par. 3-01.
3-03 Maximum Reference
Option:
MinReference (par. 3-02) - 100000.000
*
1500.000
*
default setting ()display text []value for use in communication via serial communication port
154
MG.33.B
3.22 - VLT is a registered Danfoss trademark

Danfoss VLT AutomationDrive FC 302 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 302
Category	DC Drives
Language	English