CD820 Instant Issuance System User’s Guide 21
Load and Replace Supplies
To prepare the printer to print cards, load blank card stock into the input hopper, and load print
ribbon and a cleaning sleeve onto the print cartridge.
Load Cards
If you plan to insert cards into the printer manually, skip this step and keep a supply of blank cards
near the printer.
Cards can stick together. Slide or fan the cards to separate the edges before placing them in
the input hopper. Handle cards by their edges only, or wear gloves.
Insert ISO magnetic stripe cards with the stripe (back side) facing down and to the right.
Insert smart cards with the smart card chip facing up and toward the back of the hopper.
Single Hopper
1. Unlock the printer and open the input hopper.
2. Load the cards into the input hopper.
3. Close the hopper and lock the printer when you
finish loading cards.
Optional Multi-Hopper
1. Unlock the printer and open the multi-hopper
cover.
2. Load the cards into the hoppers.
The input hoppers are labeled H1 through H6.
You can load up to 100 cards into each hopper.
3. Close the multi-hopper and lock the printer
when you finish loading cards.
A diagram inside the input hopper shows the correct orientation for each type of card.
To Next Page
Loading...
Need help?
General
