54 Troubleshooting
107: Magstripe read data error
The printer failed to read the magnetic stripe data from the card. The card will be canceled.
1. Make sure that you are using magnetic stripe cards that match the printer settings.
2. Make sure that the cards are placed in the printer correctly.
Press the U
SER button on the printer to send a new card to the printer.
HINTS & TIPS
The data might use a different format than the current printer setting.
Ask the system administrator to verify that the card, data, and printer settings match.
108: Magstripe read no data
The printer did not find any magnetic stripe data on card. The card will be canceled.
1. Make sure that you are using magnetic stripe cards that match the printer settings.
2. Make sure that the cards are placed in the printer correctly.
Press the U
SER button on the printer to send a new card to the printer.
HINTS & TIPS
The card might have been turned the wrong way. A diagram inside the input hopper shows
the correct orientation.
The card might not have a magnetic stripe.
109: Print ribbon problem
The print ribbon is not moving properly.
1. Open the printer and remove the ribbon cartridge.
2. Reposition, repair, or replace the ribbon and advance the repaired area one full turn.
3. Replace the ribbon cartridge and close the printer.
Press the U
SER button on the printer to clear the message and send a new card to the printer.
HINTS & TIPS
Remove any debris from the print area.
If a card is in the printer, turn the manual advance knob to move the card so that the printer
can eject it.
To Next Page
Loading...
Need help?
General
