CR500 Instant Issuance System Installation and Administrator’s Guide 57
ActivityLog
Use the Printer Setting menu ActivityLog options to enable or disable an internal or external
activity log. When you specify an external log server, you can send the activity log to a syslog
server monitored by a third-party application. You specify the types of actions to include in the
logs and set the severity level for when the action should be written to the log. Filter severity
level options are: Critical, Error, Warning, Notice, Information, Debug, and Disabled.
Option Description
ExternalLog Enable or disable writing the activity log to an external Syslog server.
ExternalLogServer Specify the IP address of the external Syslog server, if ExternalLog is
set to Enabled.
FilterCardActions Write the start and completion of a card action with the specified
severity, and higher, to the activity log.
Default: Notice
FilterConfigChanges Write configuration change actions with the specified severity, and
higher, to the activity log.
Default: Notice
FilterJobStates Write changes to the state of a print or exception job with the
specified severity, and higher, to the activity log.
Default: Notice
FilterSoapMsgs Write DPCL/Soap (Simple Object Access Protocol) messages from the
printer with the specified severity, and higher, to the activity log.
Default: Notice
FilterSystem Write system information with the specified severity, and higher, to
the activity log. A value of Information results in most events being
written to the log.
Default: Notice
InternalLog Enable or disable the activity log on the printer.
Default: Enabled
To Next Page
Loading...
Need help?
General
