CR500 Instant Issuance System Installation and Administrator’s Guide 69
Update Password
You can specify to password protect Printer Manager and limit access to the advanced settings.
Adding password protection is the preferred method of restricting access to Printer Manager. If
no password is assigned, a password is not needed to log on to Printer Manager.
Do the following to change the password:
1. Select the access level for which you want to assign a password. The WebAdmin access level
can update the WebAdmin, WebUser, SnmpRwCommunity, and SnmpRoCommunity
passwords.
2. Enter the current password. If a current password is not set, leave this field blank.
3. Enter the new password in the corresponding field. To remove a password, leave this field
blank.
4. Enter the new password again to confirm it. Leave the field blank if you are removing the
password.
5. Click Update Password to apply the changes.
HINTS & TIPS
Passwords are hierarchical in the following order: WebService, WebAdmin, and WebUser. You
can use a password that is higher in the hierarchy to log on to a specific role.
Passwords may contain the following characters: a–z, A–Z, 0–9, +, and /.
Set Job Queue State
Enter or select values prior to shipping the printer or system to or from repair facilities.
Refer to “Set Job Queue State” on page 55 for more information.
Caution: Do not change the WebService password.
To Next Page
Loading...
Need help?
General
