Inspection and Model Explanation ASDA-B2-F
1-2 September, 2015
1
1.1 Inspection
In order to prevent the negligence during purchasing and delivery, please inspect the following
items carefully.
Item Description
Please check if the product
is what you have
purchased.
Check the part number of the motor and the servo drive on the nameplate.
Refer to the next page for the model explanation.
Check if the motor shaft
can rotate smoothly.
Rotate the motor shaft by hand. If it can be rotated smoothly, it means the
motor shaft is normal. However, it cannot be rotated by hand if the motor
has an electromagnetic brake.
Check if there is any
damage shown on its
appearance.
Visually check if there is any damage or scrape of the appearance.
Check if there is any loose
screw.
Make sure no screw is un-tightened or fall off.
If any of the above situations happens, please contact the distributors to solve the problems.
A complete and workable servo set should include:
(1) One servo drive and one servo motor.
(2) One UVW motor power cable, the U, V and W wires can connect to the socket attached by
the servo drive and another side is the plug which could connect to the socket of the motor.
And a green ground wire which should be connected to the ground terminal of the servo
drive. (selective purchase)
(3) An encoder cable which connects to the socket of the encoder. One side of it connects to
CN2 servo drive and another side is the plug. (selective purchase)
(4) 15-PIN connector which is used in CN1 (selective purchase)
(5) 9-PIN connector which is used in CN2. (selective purchase)
(6) 6-PIN connector which is used in CN3. (selective purchase)
(7) RJ-45 connector which is used in CN6.
To Next Page
Loading...
Need help?
General
