Delta RPI M6A User Manual

8 Settings
Installation and Operation Manual for RPI M6A M8A M10A inverters V1.0 2016-02-03
74
Accessing the menu
Main menu > Install Settings > Grid settings > Voltage Protection
E-Today: 0kWh
Power: 0W
Status: On Grid
10.Sep 2014 15:32
1. When the default information is displayed, press any button to open the main menu. Oth-
erwise, repeatedly press the button
ESC
until the main menu is displayed.
Inverter Info.
General Settings
Install Settings
Active/Reactive Pwr
FRT
2. Use the buttons and to select Install Settings.
To conrm your selection, press the button
ENT
.
Password: * * * *
energy production
Adj. would effect
Warning:
3. Type in the password you received from Delta Support. Use the buttons and to
set each digit.
To conrm a digit, press the button
ENT
.
Grid Settings
Country
Insulation
Inverter ID: 001
4. Use the buttons and to select Grid settings.
To conrm your selection, press the button
ENT
.
Freq. Protection
Reconnect T: 600s
P Ramp up: 6000%/m
Voltage Protection
5. Use the buttons and to select Voltage protection.
To conrm your selection, press the button
ENT
.
High On: 259.0V
High Off T: 0.3s
Low Off: 104.0V
High Off: 276.0V
6. If you need to change a parameter, use the buttons and to select the parameter.
7. Press the button
ENT
to start editing the parameter value.
8. Use the buttons and to change the parameter value.
To conrm your setting, press the button
ENT
or press the button
ESC
to cancel the ac-
tion.
9. Repeat steps 6 to 8 for the other parameters if you need to change them.
Do not change this setting without prior
consultation with Delta Solar Support.

Delta RPI M6A Specifications

General

Brand	Delta
Model	RPI M6A
Category	Inverter
Language	English