00
Getting Started Connections Settings Playback Remote ControlMulti-zone Information Troubleshooting SpecificationsRemote Control
ENGLISH
Operating the Main Remote Control Unit
The included main remote control unit can be preset to operate
devices of various brands.
Presetting
Some brands have more than one preset code. If the component
does not operate, try inputting a different code.
Depending on the model and year of manufacture of your equipment,
some buttons may not operate. In such cases we recommend using
the learning function. (vpage 104 “Learning Function”)
•
•
1
Press [DVD/HDP], [VCR/DVR], [TV] or [SAT/CABLE]
for the device you want to preset.
2
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice.
3
Press [0 ~ 9] and input the 5-digit number of the
brand of the component to be preset. The numbers
are shown in the Preset Code Table (vEnd of this
manual).
When the code is registered, the signal transmission indicator
flashes twice.
When the preset code is transmitted, the mode indicator for the
component to which that code belongs flashes.
The input mode is canceled if no button is operated for 10
seconds.
b
In ZONE2, ZONE3 and ZONE4 modes, you can switch the MAIN
ZONE power on or off by pressing [POWER ON] or [POWER OFF].
[QUICK SELECT], [MUTE] and [MASTER VOLUME] can also be
operated when the device selected is something other than [MAIN].
In this case, the zone you used last can be operated. Check using
the zone indicator.
•
•
The mode switches each time [MAIN] is pressed.b
G
MAIN modeH GZONE2 modeH GZONE3 modeH
GMACRO modeH GZONE4 modeH
2
Operate the component.
For details, refer to the component’s operating instructions. b
To Next Page
Loading...
Need help?
General
Weight and Dimensions
