0
Getting Started Connections Settings Playback Remote ControlMulti-zone Information Troubleshooting SpecificationsRemote Control
ENGLISH
Operating the Main Remote Control Unit
Specifying the Zone Used with the Main
Remote Control Unit
When the [MAIN] Device Select button is pressed, only the set zone
can be operated with the main remote control unit.
1
Press [MAIN] to light the “MAIN” zone indicator.
2
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice.
3
Press [9], [9] and [9], in that order.
The signal transmission indicator flashes twice and the backlight
on time setting mode is set.
4
Press [1 ~ 4] to set.
The signal transmission indicator flashes twice.
[Settable items]
[1] : When only using “MAIN” / “MACRO”
[2] : When using “MAIN” / “Z2” / “MACRO”
[3] : When using “MAIN” / “Z2” / “Z3” / “MACRO”
[4] : When using “MAIN” / “Z2” / “Z3” / “Z4” / “MACRO”
(Default)
Resetting the Main Remote Control Unit
Learning Function
Resetting Button by Buttonn
Resetting by Device Moden
1
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice.
2
Press [9], [7] and [6], in that order.
The signal transmission indicator flashes twice.
3
Press [DEVICE SELECTOR] for the device you want to
reset twice.
The signal transmission indicator flashes twice.
1
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice.
2
Press [9], [7] and [6], in that order.
The signal transmission indicator flashes twice.
3
Press the button you want to reset twice.
The signal transmission indicator flashes twice.
MACRO Function
Punch-Through Function
All Settings
1
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice.
2
Press [9], [8] and [4], in that order.
The signal transmission indicator flashes twice.
3
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice.
1
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice.
2
Press [9], [8] and [1], in that order.
The signal transmission indicator flashes 4 times.
All the settings are restored to their defaults.
1
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice.
2
Press [9], [7] and [8], in that order.
The signal transmission indicator flashes twice.
3
Press [MACRO] (1 ~ 3) you want to reset.
4
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
