Getting Started Connections Settings Playback Remote ControlMulti-zone Information Troubleshooting SpecificationsPlayback
ENGLISH
Adjusting the Volume of Groups of Speakers
(Fader Function)
This function lets you adjust (fade) the sound from all the front (Front
speaker / Front height speaker / Front wide speaker / Center speaker)
or rear (Surround speaker / Surround Back speaker) speakers at once.
1
Use i to select “Fader”, then select the item to be
adjusting using o or p.
2
Use o p to adjust the volume of the speakers.
(o : front, p: rear)
The fader function does not affect the subwoofer.
The fader can be adjusted until the volume of the speaker adjusted
to the lowest value is –12 dB.
•
•
You can adjust the channel level either according to the playback
sources or to suit your taste, as described below.
Adjust the Volume of the Different Speakers
1
Press [CHANNEL LEVEL].
2
Use ui to select the speaker.
The speaker that can be set switches each time one of the
buttons is pressed.
3
Use o p to adjust the volume.
In the case of a subwoofer, press o when it is at “–12 dB” will
change the setting to “OFF”.
b
When a headphone jack is inserted, the headphone channel level can
be adjusted.
With this function, you can set the AVR-4810 so that the power is
automatically switched to standby after the set amount of time has
passed.
This is convenient for playing sources while going to sleep.
To cancel the sleep timer
Press [SLEEP] to set “OFF”.
The “ ” indicator on the display turns off.
n
The sleep timer setting is canceled if the AVR-4810’s power is set to
standby or turned off.
The sleep timer function can be set separately for the different zones
(vpage 99 “Sleep Timer Function”).
•
•
Press [SLEEP] and display the time you want to set.
The “ ” indicator on the display lights.
The time switches as shown below each time [SLEEP] is pressed.•
Setting the Power to Standby After a
Certain Amount of Time
(Sleep Timer Function)
Adjust the Volume of the Speakers
Convenient Functions
GQuick Select DefaultsH
Input Source Volume
Quick Select 1 DVD –40dB
Quick Select 2 SAT/CBL –40dB
Quick Select 3 VCR –40dB
Calling the Settings Out
Naming Quick Select settings
See “Quick Select Name” (vpage 54).
n
NOTE
Input sources stored with the quick select function cannot be selected
if they have been deleted at “Source Delete” (vpage 52). In this
case, store them again.
The Quick Select function can be set separately for the different zones
(vpage 98 “Quick Select Function”).
Press QUICK SELECT at which the settings you want to
call out are saved.
The “ ”, “ ” or “ ” indicator lights on the display.
All of the settings in step 1 can be memorized together. By memorizing
frequently used settings, you can quickly access and enjoy a playback
environment that is consistently the same.
Saving the Settings
1
Set the items below to the settings you want to save.
q Input Source (vpage 30)
w Volume Level (vpage 76)
e Surround Mode (vpage 78)
r Audyssey Setting
(MultEQ
®
XT, Dynamic EQ™, Dynamic Volume™) (vpage
83, 84)
t Video Select (vpage 60)
2
Press and hold the desired QUICK SELECT until
“Memory” appears on the display.
The current settings will be memorized.
Saving Frequently Used Settings
(Quick Select Function)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
