3590EKR, 3590EXP, 3590EXT, CPWE, CPWET series indicator E-AF09_02_16.03_EN_U
5.5.2 IN WEIGHING
NON VALID OR UNSTABLE
WEIGHT
Printing or totalisation not possible with weight at 0, negative, unstable, or out of the
totalisation field.
It’s showed on the LCD display when you try to print or totalize with the weight 0 or
negative
Turning off of the instrument through the key (see section 3.4).
OVERLOAD
The weight is 9 divisions above the Maximum Capacity.
Approved instrument: the weight is under the gross zero (-100 divisions).
OR
UNDERLOAD
- Approved instrument:
The weight is under the gross zero (-100 divisions).
- Non approved instrument:
The weight is under the gross zero (- capacity – 9 divisions).
Execution of scale zero (see section 6).
Tare execution (see section 7).
Tare cancellation (see section 7.3)
Turning on printer for maintenance (see section 3.5).
Visualisation of the gross weight.
Visualisation of the net weight.
Tare lock or enabled keyboard function.
Tare lock or disabled keyboard function.
ENTER=RETRY
C=CANCEL PRINTOUT
Error during printing: press ENTER to restore the printing or C to cancel it and repeat
it through the procedure described in section 13.
PRINTER ERROR:
CHECK THE CTS!
Error during the printing: totalisation not possible or printing not executed / finished.
6. SCALE ZERO FUNCTION
Keep the ZERO key pressed; the message "Zero" appears on the display after which:
- If the weight on the scale is included in the percentage configured in the << 0.PErC >> (RIF.MAN.T.) step, and is stable, it
is zeroed;
- If the weight is not within this range, it will not be cleared and an error sound is emitted.
And the indicator automatically returns to the display of the weight present on the scale.
7. TARE FUNCTIONS
7.1 MANUAL PRESET TARE TO BE SUBTRACTED TO THE TOTAL ACCUMULATED WEIGHT
To enter the tare value, one can do it in several ways:
1) With the keyboard, type the value (including the decimal point) and press TARE.
The C key quickly zeros the current value.
2) Select a vehicle linked to a tare different than 0.
The indicator automatically subtracts the entered value from the accumulated total weight through one of the available axle
totalization procedures (see section 3) as long as it is not greater than it, at the end of the input or output axle totalization
cycle (see section 13.3.6).
To Next Page
Loading...
Need help?
General
