3590EKR, 3590EXP, 3590EXT, CPWE, CPWET series indicator E-AF09_02_16.03_EN_U
CPWE
- Then the indicator executes the input cycle end printout, and then displays the total of the axles in the weight section
(see section 5) for a few seconds:
3590E
LED display LCD display
alternatively to
CPWE
alternatively to
[In which: XXXXXX is the acquired overall weight value]
- At this point, it returns in the status of waiting for the input or output weighing cycle start.
13.3.1.3 STARTING OUTPUT WEIGHING THROUGH ID CODE
To enable this mode, one has to set the step F.ModE >> totAL >> WEi.MEM on “Wei.Cod” in the setup (TECH.MAN.REF.).
Procedure
- Select, if requested, the customer / material / vehicle to be linked to the output weigh.
- Drive and stop the first axle of the vehicle on the scale: then it’s possible to proceed in two ways:
1) Directly type in the ID code and press F7
2) Press F7: one enters the menu of the “open” input weighs:
LCD display
total
WEIGH AXLE 3 ?
ENTER=YES C=NO
print
WEIGH AXLE 3 ?
ENTER=YES C=NO
To Next Page
Loading...
Need help?
General
