3590EKR, 3590EXP, 3590EXT, CPWE, CPWET series indicator E-AF09_02_16.03_EN_U
Select the desired weigh using the arrow keys .
Confirm with ENTER or press C to exit.
13.3.1.4 STARTING OUTPUT WEIGHING THROUGH LICENSE PLATE
To enable this mode, one has to set the step F.ModE >> totAL >> WEi.MEM on “PLAtE” in the setup (TECH.MAN.REF.).
Procedure
- Select, if requested, the customer / material / vehicle to be linked to the output weigh.
- Drive and stop the first axle of the vehicle on the scale.
- Press F7, the display shows:
- Then it’s possible to proceed in two ways:
1) Enter the License Plate number and press ENTER
2) Press ENTER: one enters the menu of the “open” input weighs
LCD display
Select the desired weigh using the arrow keys .
Confirm with ENTER or press C to exit.
13.3.1.5 OUTPUT WEIGHING PROCEDURE
- After having selected the input weigh, the indicator waits for the stability, then acquire the weight, emits a sound and
displays for an instant the following message:
3590E
LED display LCD display
CPWE
- Then the acquired weight blinks for a few seconds in the weight section (see section 5), and the indicator executes
the printout (if set):
3590E
LED display LCD display
CPWE
WEIGH AXLE 2?
ENTER=YES C=NO
tot
WEIGH AXLE 2 ?
ENTER=YES C=NO
WEIGH AXLE 2?
ENTER=YES C=NO
To Next Page
Loading...
Need help?
General
