Troubleshooting
112
Problems with WirelessHD (EH-TW6700W only)
Cannot project WirelessHD images
Check Remedy
Does the cable connecting the supplied Wire-
lessHD Transmitter meet the HDMI stand-
ards?
If the cable does not meet the HDMI standards, operations are
not possible.
Is WirelessHD set to Off? When WirelessHD is set to Off from the Configuration menu,
projection is not possible for WirelessHD input signals. Set Wire‐
lessHD to On, and then press the
button. s Settings -
WirelessHD - WirelessHD p.89
Are signals being received within the Wire-
lessHD transmission range?
Check the range within which the WirelessHD's transceiver can
communicate, and view within that range.
s p.66
Is the supplied WirelessHD Transmitter
turned on?
Check the power lamp on the WirelessHD Transmitter. If there is
no power being supplied, make sure the connector for the AC
adapter is securely connected, and then turn on the power
switch.
Is the WirelessHD indicator for the supplied
WirelessHD Transmitter off?
The WirelessHD cannot communicate with the projector. Check
the range within which the WirelessHD's transceiver can com-
municate, and setup within that range.
Is the Link indicator for the supplied Wire-
lessHD Transmitter off?
No signal is output from the AV device connected to the Wire-
les sHD Trans mit ter . Check tha t th e ca bl es from the AV devi ce an d
the WirelessHD Transmitter are securely connected.
Has dust collected in the WirelessHD Trans-
mitter's vent?
There is an air exhaust vent on the bottom of the WirelessHD
Transmitter. Communication may not be possible if dust has col-
lected in the vent. Install the projector so that dust does not col-
lect in the vent.
Are the projector and the WirelessHD Trans-
mitter facing the correct way?
Setup the projector and the WirelessHD Transmitter so that they
are facing each other.
Interference, distortion, or interruption appear in WirelessHD
Check Remedy
Are signals being received within the Wire-
lessHD transmission range?
Check the range within which the WirelessHD's transceiver can
communicate, and view within that range.
s p.66
Are there any obstructions between the Wire-
lessHD Transmitter and the projector?
Because WirelessHD communicates using a tight beamed elec-
tromagnetic wave, if there are any people or objects and so on
obstructing the communication path, this could have an adverse
affect on the image. Make sure that there are no obstacles be-
tween the WirelessHD Transmitter and the projector within the
WirelessHD transmission range.
s p.66
Downloaded from www.vandenborre.be
To Next Page
Loading...
Need help?
General
