Epson LX-300+II RTP User Manual

EPSON LX-300+II/300+II RTP/1170II Revision D
LX-300+II RTP DISASSEMBLY AND ASSEMBLY 98
About LX-300+II RTP, this service manual has only the chapters of the
DISASSEMBLY AND ASSEMBLY, ADJUSTMENT, Parts List and Exploded
Diagram.
7.1 DISASSEMBLY AND ASSEMBLY
This section explains the disassembly and assembly of LX-300+II. Unless otherwise
specified, assembly can be done in the reverse order of the disassembly procedure.
Anything that service person should pay attention to is described under “Check Point”.
Any adjustment required after assembly is described under “Adjustment”.
When you have to remove parts that are not described in this chapter, refer to the
exploded diagram on Appendix of this manual.
The figure below is the disassembly flowchart for main component.
Flowchart 7-1. Disassembly Flowchart (Main Component)
C A U T I O N
Remove ink ribbon and paper before disassembling the printer.
7.1.1 “Printhead Unit
Removal”
7.1.4 “Panel Board
Assembly Removal”
7.1.3 “Printer Mechanism
Removal”
7.1.6 “P/S Board Assembly
Removal”
7.1.5 “Main Board
Assembly Removal”
START
7.1.2 “Upper Housing
Unit Removal”

Epson LX-300+II RTP Specifications

General

Brand	Epson
Model	LX-300+II RTP
Category	Printer
Language	English