Media is not fed straight or taken up
well
o
Has parallel adjustment been performed for
the Media Feeding Unit and Auto Take-up
Reel Unit?
Perform parallel adjustment for the Media Feeding
Unit and Auto Take-up Reel Unit when there are
problems with media feeding or take-up and after
moving the printer.
U “Parallel adjustment” on page 118
o
Is take-up occurring with the printed side
facing out?
Take up media with the printed side facing in.
o
Is narrow media being taken up?
We recommend using media with a width of 36 inches
or greater.
o
Is thick media being taken up?
When thick printed media is being taken up, we
recommend setting the print settings of the software
RIP to 3 passes or higher.
Others
The after heater automatically turns
Off
o
The after heater will turn off if no print job is received
for some time and no error occurs. The time before the
after heater turns off automatically can be selected
using the Heat Off Timer option in the setup menu.
U “Printer Setup Menu” on page 96
The after heater will be reactivated when a print job is
received, the media loading lever is used, or another
operation involving printer hardware is performed.
The control panel display keeps
turning off.
o
Is the printer in sleep mode?
The printer enters sleep mode when the Heat Off
Timer expires and the heaters turn off. The time
before the after heater turns off can be selected using
the Printer Setup menu.
U “Printer Setup Menu” on page 96
The after heater will be reactivated and sleep mode
will end when a print job is received, the media
loading lever is used, or another operation involving
printer hardware is performed.
The red light is on inside the printer.
o
This is not a failure.
The red light is a light inside the printer.
The administrator password has been
forgotten.
o
Reset the password.
At the Network Setup menu of the control panel, run
Restore Settings, and then set a new password.
U “The Network Setup Menu” on page 99
SC-F9200 Series User's Guide
Problem Solver
110
To Next Page
Loading...
Need help?
General