Item Parameter Explanation
Roll Type
Printable Side
Out
Choose Printable Side Out or Printable Side In according to how the
media is rolled.
Printable Side
In
Tension Measurement
Periodically The tension is measured and adjusted automatically to maintain the
correct tension for the media being printer.
Periodically is recommended in most circumstances.
Select Every Page for more precise tensioning, but note that print times
will increase.
Every Page
Feeding Tension
Auto -
The default setting of Auto is recommended in most situations. If creases
appear in the media during printing, we recommend using Manual and
setting the value to higher than Lv32.
When banding (horizontal banding, tint unevenness, or stripes) occurs in
printing results, we recommend using Manual and setting the value to
lower than Lv32.
When Media Size Check is set to Off, set Manual, and then set Feeding
Tension to a recommended value that complies with the width of the
loaded media. For details, see:
U “Feeding Tension” on page 46
Manual 0 to 40
Take-up Tension
Auto -
The default setting of Auto is recommended in most situations. If media
wrinkles when printing, or white banding (white or light lines) appears in
the print results, we recommend using Manual and setting the value to
lower than Lv7. Make the same settings if ink adheres to the back of the
take-up roll. If thick media cannot be wound correctly, we recommend
using Manual and setting the value to higher than Lv7.
Manual 1 to 9
Prevent Sticking On
Select whether to enable (On) or disable (Off) operations to prevent
media from sticking when the printer is turned on or when printing starts.
Since operations take longer when On is selected, we recommend setting
this to Off. Depending on the media type, it may easily adhere to the
platen. If operations are performed while the media is on the platen, and
the media is not fed correctly causing a jam, set On.
Off
Restore Settings Yes
If Yes is selected, the content of configured RIP Settings are returned to the
default settings.
No
Print Media List
Parameter Explanation
Print Print the contents of media setting banks 1 to 30.
Printer Setup Menu
is the default setting.
SC-F9200 Series User's Guide
Using the Control Panel Menu
96
To Next Page
Loading...
Need help?
General