Supported Media
The following media can be used with the printer.
Print quality is greatly affected by the type and quality of
media used. Choose a media suited to the task at hand.
For information on use, refer to the documentation
supplied with the media or contact the manufacturer.
We recommend that you print a test run and check the
results before purchasing media in large quantities.
c
Important:
Do not use media that is wrinkled, scuffed, torn, or
dirty.
Standard Roll Media System
Roll core size 2 or 3 inch
Roll outer diameter Up to 250 mm
Media width 300 to 1626 mm (64 inches)
Media thickness Up to 1mm
Roll weight Up to 40kg
Moving and Transporting
the Printer
This section describes how to move and transport the
product.
Moving the Printer
This section assumes that the product is being moved to
another location on the same floor without traversing
stairs, ramps, or lifts. See below for information on
moving the printer between floors, to another building,
or between non-level floors.
U “Transport” on page 113
Caution:
Do not tilt the product more than 10 degrees
forward or back while moving it. Failure to observe
this precaution could result in the printer falling
over, causing accidents.
Getting Ready
Remove the media guide bar when the frontage or
passageway is narrow.
U “Removing the Media Guide Bar” on page 113
A
Confirm that the printer is off.
B
Remove the Waste Ink Bottle.
U “Replacing the Waste Ink Bottle” on
page 74
C
Disconnect the power cords and all other cables.
D
Remove media from the Media Feeding Unit and
Auto Take-up Reel Unit.
SC-F9200 Series User's Guide
Appendix
112
To Next Page
Loading...
Need help?
General