N Large alert lamp
Lit or flashing when an error or warning occurs in the printer.
On : An error occurred. Check the contents of the error on the control panel's screen.
Flashing : An ink or paper low warning occurred. You can specify for which consumable this warning
should occur. The factory default setting is Off (do not warn).
U “Preferences” on page 120
Off : No error.
O Printer cover
Open when loading thick paper, cleaning the inside of the printer, or removing jammed paper. Normally closed
when using the printer.
P Rear manual feeder
Manually feed paper into this slot when printing cut sheets one at a time.
U “Loading Manually from the Rear” on page 44
Q Paper support
Raise this support when manually feeding paper to load the paper properly. Supports paper to prevent it from
falling forward or backward.
R Edge guide
Move left and right depending on the size of the paper that you want to load. This prevents paper being fed at a
slant.
S Roll paper feeder
Paper feed slot for roll paper printing.
U “Loading Roll Paper” on page 31
T Roll paper cover
To prevent the inside of the printer from getting dusty, keep this closed except when replacing roll paper.
U Spindle holders
Holds the spindle loaded with roll paper. There is one on both the left and the right sides.
U “Loading roll paper” on page 33
SC-P5000 Series User's Guide
Introduction
13