7.
Send the fax.
Note:
You cannot send another fax until the fax has been sent at the specied time. If you want to send another one, you need
to cancel the scheduled fax by selecting Fax on the home screen, and then deleting it.
Related Information
& “Placing Originals” on page 58
& “Sending Faxes Automatically Using the Control Panel” on page 139
& “Fax Settings” on page 147
Sending
Dierent
Size Documents Using ADF (ADF Continuous Scan)
Sending faxes by placing originals one by one, or by placing originals by size, you can send them as one document
at their original sizes.
If you place dierent sized originals in the ADF, all of the originals are sent at the largest size among them. To send
originals at their original sizes, do not place originals with mixed sizes.
1.
Place the rst batch of originals at the same size.
2.
Select Fax on the home screen.
To select an item, use the
u
d
l
r
buttons, and then press the OK button.
3.
Specify the recipient.
4.
Select the Fax Settings tab, and then select ADF Continuous Scan to set this to On.
You can also make settings such as the resolution and the sending method as necessary.
5.
Press the
x
(Send) button.
6.
When scanning the rst set of originals is complete and a message is displayed on the control panel asking you
to scan the next set of originals, select Ye s , set the next originals, and then press the
x
button.
Note:
If you leave the printer untouched for 20 seconds aer prompted to set the next originals, the printer stops storing and
starts sending the document.
Related Information
& “Placing Originals” on page 58
& “Sending Faxes Automatically Using the Control Panel” on page 139
& “Fax Settings” on page 147
Receiving Faxes on the Printer
If the printer is connected to the phone line and basic settings have been completed using the Fax Setting Wizard,
you can receive faxes.
Faxing
>
Receiving Faxes on the Printer
143
To Next Page
Loading...
Need help?
General