Placing an ID Card for Copying
Place an ID card 5 mm away from the corner mark of the scanner glass.
Managing Contacts
Registering a contacts list allows you to easily enter destinations. You can register up to 100 entries, and you can
use the contacts list when you enter a fax number.
Registering or Editing Contacts
1.
Select Fax on the home screen.
To select an item, use the
u
d
l
r
buttons, and then press the OK button.
2.
Select Contacts.
3.
Do one of the following.
❏ To register a new contact, select Add Entry by pressing the + button, and then select Add Contact.
❏ To edit a contact, move the cursor to the target contact by using the
u
d
buttons, press the
r
button, and
then select Edit.
❏ To delete a contact, move the cursor to the target contact by using the
u
d
buttons, and then press the
r
button. Select Delete, and then select Ye s . You do not have to perform following procedures.
4.
Make the necessary settings.
Note:
When entering a fax number, enter an external access code at the beginning of the fax number if your phone system is
PBX and you need the access code to get an outside line. If the access code has been set in the Line Type setting, enter a
hash (#) instead of the actual access code. To add a pause (pause for three seconds) during dialing, enter a hyphen (-).
5.
Select Done to apply the settings.
Related Information
& “Entering Characters” on page 19
Preparing the Printer
>
Managing Contacts
>
Registering or Editing Contacts
63
To Next Page
Loading...
Need help?
General