EVS XT Series User Manual

Issue
10.01.D
XT Series DISK RECORDER
–
Version 10.01 - Software Technical Reference
EVS Broadcast Equipment SA
–
October 2009
18
1.3.7 HYPERMOTION MANAGEMENT
PRINCIPLES
The hypermotion cameras can now be controlled by the LSM Remote Panel. The
camera is linked via a RS422 or Ethernet connector to the same XT[2] server as
the controlling Remote Panel.
In setups including a hypermotion camera, the following principles apply:
• An XT[2] server can not control more than one hypermotion camera.
• The hypermotion camera is used with the classical channel configurations.
• Not all Multicam LSM configurations with several PGMs and several Remotes
are supported within the current RS422 and channel configuration constraints.
• If the Recorder Mode setting on the Remote Panel setup (page 6.4, F3) is set
to ‘Hypermotion only’, an additional Remote Panel is made available in the Main
menu of the LSM Remote.
REMOTE PANEL ASSIGNMENT
In setups where several LSM Remotes and a hypermotion camera are defined, the
assignment of the various PGMs and hypermotion camera to the Remote Panels is
automatically performed as shown in the table below depending on:
• the number of PGMs in the selected channel configuration
• the selected Remote Mode (Hypermotion only or Hypermotion + LSM)
• the number of Remote Panels available
The following table presents the possible configurations:
Important
The cells with ‘NA’ correspond to impossible configurations taking into
account the existing constraints. In this case, the Hypermotion option is
not available in the operational menu even if the Hypermotion setting is
set to ‘Yes’.

EVS XT Series Specifications

General

Brand	EVS
Model	XT Series
Category	Computer Hardware
Language	English