To Next Page

To Previous Page

Issue

10.01.D

XT Series DISK RECORDER

–

Version 10.01 - Software Technical Reference

EVS Broadcast Equipment SA

–

October 2009

When the initialization is complete, the system displays the message "HCTX board

initialized" and the system is ready. If an error occurs, the message "ERROR

(0xErr): HCTX board not correctly initialized" is displayed. The error (Err) are

detailed in the following section.

Possible Errors

If an error is detected while loading tables, the following message is displayed: "

LOAD <TAB>LE ERROR – state = [St]" where ‘St’ can be:

1. Block error A disk error occurred while loading the table on

hard disks. Maybe a disk failure. Replace disks.

2. Cache overflow error No more blocks available in cache. Algorithm

problem. Contact EVS.

3. Checksum error This can occur if a disk has been replaced and

data not rebuilt on it. Rebuild data on the disk to

clear the message. If no disk has been replaced,

try to re-start the server to clear the error

message. If it does not resolve it after a few re-

start, a clear clip will be necessary.

4. Signature error The signature on the table file is not found in the

header file. Try to re-start the server to clear the

error message. If it does not resolve it after a few

re-start, a clear clip will be necessary.

If the message "INIT ERROR: TIMED OUT – state = [St]" is displayed, it means

the initialization is not complete. ‘St’ refers to a position in the code.

Note:

Never forget that to start Multicam, the bootwins must successfully

initialize the microcode. In that case, the message "HCTX board

initialized" is displayed. In all other error case, the boot sequence or

initialization phase is cancelled and multicam cannot be started.

EVS XT Series User Manual

Other manuals for EVS XT Series