EVS XT Series User Manual

XT Series DISK RECORDER - Version 10.01 - Software Technical Reference Manual Issue
10.01.D
EVS Broadcast Equipment SA
–
October 2009
31
REF & PHASE AREA
Ref Type
Possible values: [SD Black Burst, HD Tri-Level Sync]
This parameter allows selecting the genlock reference input between:
• SD Black Burst (default)
• HD Tri-Level Sync (HD only)
Sync Mode
Possible values: [Studio mode, Resync mode]
This parameter allows selecting the frame synchronizer mode between:
• Studio mode: should be used when the video input signals are synchronized.
(default)
• Resync mode: should be used when the video input signals are not
synchronized. In this case, they will be re-synchonized on the digital I/O board.
This can cause a shift of up to 3 fields between the various video input signals.
Genlock
Possible values:[OK or BAD]
This information is automatically displayed.
This parameter checks if the Genlock input is valid.
TC In
This parameter displays the status of the LTC input of the server, and the video
format corresponding to the incoming timecode.
Ex: “TC in 12:24:45:09 PAL” or “TC in 12:24:45:09 NTSC”. If no valid timecode is
detected, the display will show “TC in --:--:--:-- Bad”.
Phase
This parameter shows the value currently set for the main video phase of the
digital video outputs. Refer to the ‘Phase Definition’ section for details.

EVS XT Series Specifications

General

Brand	EVS
Model	XT Series
Category	Computer Hardware
Language	English