EVS XT Series User Manual

Issue
10.01.D
XT Series DISK RECORDER
–
Version 10.01 - Software Technical Reference
EVS Broadcast Equipment SA
–
October 2009
54
3.1.2 HOW TO DISCONNECT A MACHINE FROM THE SERVER
The operator has the possibility to disconnect a machine from the XNet network.
This can be useful when setting up an SDTI network or troubleshooting an SDTI
network issue. This is only possible when using a XHub with version 3.03.
To disconnect a machine from the server, proceed as follows:
1. Press SHIFT-F4 to access the SDTI Network Monitoring screen.
2. Press CTRL-ALT-L to disconnect the XHub branch from the network.
The following warning is displayed:
Warning
The network branch you are connected on
will be disconnected from the network.
All network actions will be disabled.
ESC: Cancel ENTER: Confirm
3. Press ENTER to confirm that you want to disconnect the XHub branch from
the network.
On the SDTI Network Monitoring screen, the following message in red font informs
that the machine is disconnected and how it can be connected again:
“XHub branch disconnected from the network. Press CTRL-ALT-L to reconnect.”

EVS XT Series Specifications

General

Brand	EVS
Model	XT Series
Category	Computer Hardware
Language	English