EVS XT Series User Manual

XT Series DISK RECORDER - Version 10.01 - Software Technical Reference Manual Issue
10.01.D
EVS Broadcast Equipment SA
–
October 2009
41
1.4.10 TS CALIBRATION
When the Touch Screen option is installed, it can be calibrated using this
command. If the Touch Screen is not installed, a warning message is displayed.
1.4.11 SET TIME
The Set Time command allows adjusting the system time & date.
Example of time format:
22:58:00 for 22 h 58 min 00 sec (24 hour display)
Example of date format (dd-mm-yyyy):
24-10-2007 for October 24, 2007
15-03-2008 for March 15, 2008
1.4.12 HARDWARE CHECK / RAID REBUILD
The purpose of this tool is to check the hardware and to verify the validity of the
data recorded on the video disk array. After the selection of this command from
the Maintenance menu, the system automatically starts the test process.
One after the other, the different stages are displayed in the BOOT.HCTX window.
The test process is complete when the HCTX board is initialized.
Important:
Hardware check is also used to rebuild the video and audio information
after replacing a faulty disk.
DISK ERRORS AND DISCONNECTION
When one disk of the video raid array has sustained errors, the Multicam
automatically disconnect that disk and use the parity disk to rebuild the missing
data and provide the video and audio data blocks to the application. The operator
can thus continue working normally and the message “!Dsk” appears on all
monitoring outputs.
When exiting the Multicam application, a warning will appear to remind the
operator that one disk was disconnected, and invite him to perform a hardware
check to repair the video raid:
To protect disk array integrity, a disk has been disconnected. At
the next opportunity please perform a hardware check to evaluate
the faulty disk, and perform a rebuild to correct the problem.
Enter: OK

EVS XT Series Specifications

General

Brand	EVS
Model	XT Series
Category	Computer Hardware
Language	English