172 Using the Operator Panel Menus
IP Mode
Purpose:
To configure IP Mode.
Values:
IPv4
Purpose:
To configure IPv4 settings.
Values:
• IPsec
NOTE:
• IPsec feature is available only when IPsec is enabled on the CentreWare Internet Services.
Purpose:
Disables IPsec.
Dual Stack
*
Uses both IPv4 and IPv6 to set the IP address.
IPv4
Uses IPv4 to set the IP address.
IPv6 Uses IPv6 to set the IP address.
Get IP Address DHCP / Autonet
*
Sets the IP address automatically. A random value in the range
of 169.254.1.0 to 169.254.254.255 that is not currently in
use on the network is set as the IP address. The subnet mask is
set as 255.255.0.0.
BOOTP Sets the IP address using BOOTP.
RARP Sets the IP address using RARP.
DHCP Sets the IP address using DHCP.
Panel
Use this option when you want to set the IP address manually on
the operator panel.
IP Address When an IP address is being set manually, the IP is allocated to
the printer using the format nnn.nnn.nnn.nnn. Each octet that
makes up nnn.nnn.nnn.nnn is a value in the range of 0 to
254. 127 and any value in the range of 224 to 254 cannot be
specified for the first octet of a gateway address.
Subnet Mask When an IP address is being set manually, the subnet mask is
specified using the format nnn.nnn.nnn.nnn. Each octet that
makes up nnn.nnn.nnn.nnn is a value in the range of 0 to
255.255.255.255.255 cannot be specified as the subnet
mask.
Gateway
Address
When an IP address is being set manually, the gateway address
is specified using the format nnn.nnn.nnn.nnn. Each octet
that makes up nnn.nnn.nnn.nnn is a value in the range of 0 to
254. 127 and any value in the range of 224 to 254 cannot be
specified for the first octet of a gateway address.
To Next Page
Loading...
Need help?
General
