228 Troubleshooting
Color Registration Is out of Alignment
Protrudent/Bumpy Paper
Problem Action
Color registration is out of
alignment.
Adjust the settings of the paper type on the print driver to those of the tray or feeder.
If the problem persists, execute auto color registration adjustment.
Execute auto color registration adjustment.
1 On the operator panel, press the (Menu) button and select Admin Menu →
Maintenance Mode → Adjust ColorRegi → Auto Adjust, and then press
the button.
If the problem persists, check whether or not you have spare drum cartridges.
Check whether or not you have spare drum cartridges.
If you have spare drum cartridges, replace the drum cartridges.
If you do not have spare drum cartridges, contact the Fuji Xerox local representative
office or an authorised dealer.
Replace the drum cartridges if you have spare cartridges.
See also:
• "Replacing the Drum Cartridges" on page 256
• "Installing the Drum Cartridges" on page 259
If the problem persists, contact the Fuji Xerox local representative office or an
authorised dealer.
Problem Action
Printed surface got
protrudent/bumpy.
Clean up the fusing unit.
1 Load one sheet of paper in the bypass tray, and then print a solid image all over
paper.
2 Load the printed sheet with the side to be printed on facing down, and then print a
blank sheet of paper.
If the problem persists, contact the Fuji Xerox local representative office or an
authorised dealer.
To Next Page
Loading...
Need help?
General
