3. DIGITAL SELECTIVE CALLING
3-24
3.10.2 Enable/Disable auto DSC polling
1. Press the CALL/MENU key to show the [DSC Menu].
2. Rotate the CH knob to select [Auto POS Polling] then
press the [SELECT] soft key.
3. Rotate the CH knob to select [Activation] then press
the [SELECT] soft key.
4. Select [Start] to enable transmissions to the stations or
[Stop] to disable transmissions to the stations.
5. Press the [ENT] soft key.
6. Press the [QUIT] soft key several times to exit to the radio mode.
Note 1: “ ” appears on the screen when Auto DSC polling is active.
Note 2: When the radio receives position reports from a called vessel, the NMEA 0183
DSC and DSE sentences are output to a GPS chart plotter.
3.11 Auto CH Switch Time
This feature allows you to change the switching time which is automatically shifted to
the requested channel when the Distress Alert, All Ships Call, and Group Call are re-
ceived.
1. Press and hold down the CALL/MENU key until the
[Setup Menu] appears.
2. Rotate the CH knob to select [DSC Setup] menu.
3. Press the [SELECT] soft key, then select [Auto CH
Switch Time] with the CH knob.
4. Press the [SELECT] soft key, then rotate the CH knob
to the desired time.
5. Press the [ENT] soft key to store the selected setting.
6. Press the [QUIT] soft key several times to return to ra-
dio operation.
A
SWITCH
Switch
To Next Page
Loading...
Need help?
General
