4-1
4. GENERAL SETUP
The procedures in this chapter can also be done from the HS-4721 Handset.
4.1 Display Contrast
The display contrast can be adjusted to suit environmental conditions.
1. Press and hold down the CALL/MENU key until the [Setup Menu] appears.
2. Rotate the CH knob to select [General Setup] menu then press the [SELECT] soft
key.
3. Rotate the CH knob to select [Contrast] then press the [SELECT] soft key.
4. Rotate the CH knob to set the contrast then press the
[ENT] soft key to store the selected level. The contrast
level can be set from 0 to 31.
5. Press the [QUIT] soft key several times to return to ra-
dio operation.
4.2 Time Offset
If you want to use local time, set the time difference between UTC and local time. The
offset is added or subtracted from the time received from the GPS receiver or chart
plotter. Time is only displayed when a GPS receiver or Chart Plotter is connected.
1. Press and hold down the CALL/MENU key until the [Setup Menu] appears.
2. Select [General Setup] with the CH knob then press the [SELECT] soft key.
3. Select [Time Offset] with the CH knob then press the [SELECT] soft key.
4. Rotate the CH knob to select time offset of your loca-
tion then press the [ENT] soft key to store the time off-
set. Set "00:00" to use UTC (Universal Time
Coordinated or GPS Satellite Time).
5. Press the [QUIT] soft key several times to return to ra-
dio operation.
To Next Page
Loading...
Need help?
General
