____________________________________________________________________
G1000 System Maintenance Manual Page 9-1
190-00903-00 Rev. A
SECTION 9
PERIODIC MAINTENANCE
This section contains periodic maintenance procedures for the G1000. Removal and replacement
of an LRU is on condition of failure. The procedures in this section do not pertain to any specific
aircraft configuration. For actual aircraft maintenance requirements refer to the OEM approved
aircraft maintenance documentation.
9.1 SERVICE TIMER
The G1000 stores an airframe time-in-service timer and displays this time on the MFD EIS
window. To access the timer, press the ENGINE softkey, then press the SYSTEM softkey.
Airframe total time in service is determined by on-ground and off-ground states within the
G1000. When the aircraft is determined to be airborne, the timer starts.
Figure 9-1. Total Time In Service
9.2 MAINTENANCE INTERVALS
Refer to the OEM maintenance documentation for maintenance tasks that are required to be
performed at certain intervals.
9.3 RECOMMENDED TOOLS
The following tools are used to perform the various maintenance tasks described in this section:
• Voltmeter capable of measuring 0-32 Volts DC
• Phillips Screwdriver
• 3/32nd inch Hex Tool
• Digital Level with 0.25 degrees of accuracy capability
• VHF NAV/COM/ILS Ramp Tester
• Transponder Ramp Tester including Mode S capability for Mode S transponder equipped
aircraft
• Air Data Test Set (ADTS) capable of simulating altitude up to the aircraft’s service ceiling
• GPS Indoor Repeater (if outside GPS signals cannot be acquired)
• Headset/Microphone
• Servo Mount Test Stand (T01-00110-01)
To Next Page
Loading...
Need help?
General
